Beaded Dainty Feminine Bracelet

Welcome to the beaded dainty feminine bracelet pattern instructions! If you have any difficulty following this tutorial, please post a comment at the bottom of the page on which you are stuck, and I'll do my best to help!

Step 1

Step 1 : Now add one large black seed bead (labelled in blue) to each end of fishing line coming out of the little transparent seed bead. The yellow-dotted bead will be important in the next step.

Step 2

Step 2 : Now take the two ends and cross them through the white bead marked with a yellow dot. In other words, have the two ends go through the yellow-dotted bead in opposite directions. Now you may continue adding little transparent seed beads and move on to the next repeating unit of the bracelet!

Step 3

Step 3 : And keep going and going... We're back at the point where we started, with one more repeating unit on the bracelet... When it comes time to close the bracelet, you can either add a clasp, or if you make the bracelet a little wider so that you can just squeeze your hand through it, you can close it seamlessly by doing that trick I showed you in the hello kitty lesson. Basically you treat the very first bead in the pattern (when you started the bracelet) as the very last bead in the pattern that you are now finishing (so it's a loop). And so you loop your fishing line ends through an existing bead (that first bead) as though you were looping them through a newly added bead.